White smoke after engine rebuild

First of all, there is only a little bit of white smoke when you rev the engine. It only comes out of the exhaust after the engine retuns to idle. By a little I mean nothing more than what a cigarette puts out.

It is normal for the vehicle to emit white smoke during startup in the morning or during cold seasons. The catalytic converter turns hydrocarbon gases to carbon dioxide and water in the exhaust system. First, there is white smoke exiting the left exhaust only. Before I give more details, let me recap the history of the bike. I first rebuilt the top end year ago.

Or, put ab intake manifold gasket in wrong or not tight enough. Why does my rebuilt 3make white smoke? I recently rebuilt my 5. White Smoke during Engine Start Up?

Everything was fine during the 0miles of the break-in,then I started to notice some white smoke at times. I changed the pcv and still has the problem. Sent from my SM-A750G using.

Well, I was hoping my problem was over. Not sure how to fix this one without getting taller covers with baffles (to fit over the roller rockers). A lot easier than tearing the engine apart I think. If You stop the engine for a while (minutes enough), then after restarting it, at first it does not smoke , but after a few minutes, it starts again.

The oil gets burned (deep brown) after a few. Start after rebuild- Lots of white smoke HELP! It would pour white smoke out tell it ran out of coolant.

So now the engine was rebuilt: fully rebuilt, tested and resurfaced hea all new gaskets, all new rings an obviously, new piston. This would consist of running gently at various speeds for a certain amount of time. BritBike Forum member. Blue smoke after rebuild.

Vortec engine for about six months now and did almost a complete rebuild replacing almost every internal part of the engine except for the cam shaft and piston rods. Other smoking like a dark black smoke would be fuel smoke due to fuel not burning. ATF being sucked into engine.

The most noticeable symptom of internal coolant leakage is when the white smoke is billowing out of the exhaust pipe and leaves a sweet odor in the air. That seems strange, but not impossible. After the rebuild , it always had a little bit of white smoke on startup. It went through more oil than mine (Mine: Just over 1qt after the 8k change below. His: Maybe quarts per 5k change?) No idea what shape it was in when he was done with it.

The key of longevity for any engine is regular maintenance. Any time you see a change in the behavior, you need to address it. Hears what i had done, bore and hone to suit over JE pistons, total seal ring set, fo.

In many cases, white smoke emanating from the tailpipe (often at idle once the engine reached operating temperature) typically means a worn out injector. Now this isn’t always the case, but after some trouble shooting we’re usually the go-to shop when diesel drivers need refurbishe rebuilt, or new injectors. Bthe std hatch engine ?