This feature should be used only when a known alarm condition, such as smoke from cooking, activates the alarm. The smoke alarm will automatically reset after approximately minutes, and sound the alarm if particles of combustion are still present. This smoke alarm features an ionization sensor that protects best against fast flaming and other types of fires.
The hush mode on a smoke detector is a temporary means for you to do what needs to be done without the hassle of a blaring alarm. So if you know that the smoke alarm will always be triggered when you use oil with a high smoke point , then you can hit the hush mode to desensitize the detector for about seven minutes or so. I also show the inside.
The Kidde KN-COSM-BA combination Fire Detector and Carbon Monoxide Detector pairs two life saving devices into one unit. It uses an ionization sensor and electrochemical sensor to monitor your home for potential hazards, so you will always feel safe and confident. Only then does it speak “Hush mode activated” , start a sec LED blink cycle and stop making noise. Smoke alarms must be tested regularly to make sure the battery and the alarm circuits are in good operating condition. A working smoke alarm doubles a person’s chance of surviving a fire.
It can reduce fatalities up to. Features: Ionization Technology – Better at detecting fast flaming fires. Smoke alarms are available with a pause or hush button that can be used to temporarily silence the alarm.
This is a convenient way to deal with nuisance alarms, such as those caused by burning toast or opening smoky ovens, without disabling the alarm. The voice warning feature accompanies the 85dB tone during an alarm event, and helps reduce confusion with verbal announcements such as “Replace alarm” at end of alarm life, and “Hush mode activated” when a nuisance alarm is silenced. But before replacing it, press and hold the test button for about seconds to reset the detector.
Kidde recommends that both Ionization and Photoelectric alarms be installed. The Kidde KN COSM BA Combination Carbon Monoxide The Kidde KN COSM BA Combination Carbon Monoxide and Smoke Alarm provide two important safety devices in a single unit. System announces “HUSH MODE CANCELLED” when unit resumes normal operation after Hush Mode has been cancelled. Kidde Ionization Smoke Detector with Battery Backup is Kidde Ionization Smoke Detector with Battery Backup is an ionization-sensing alarm that offers 1VAC of power with a 9-Volt battery backup for continuous protection during power outages. A defective smoke detector in a string of units can cause all alarms to keep sounding audible alarm.
On the back it states that while in hush mode the LED will blink every seconds, as it does, and resume normal function after minutes (after which it goes off again). Kidde Battery Operated Smoke Alarm, 4-pack Sealed in Lithium Battery Operate Never Replace the Battery Over the Ten-Year Life of the Alarm. Powered by a Tamper-Free Sealed Lithium Power Supply. Self-Activation Automatically Activates Unit When Attached to Mounting Bracket.
It is capable of Wireless Interconnect. Smoke AlarWhat To Do When The Alarm Sounds. Smart Hush Silences Alarm in Non-Emergencies. If not then depending upon the condition of the rooms, you should be able to hush the system by finding which of the alarms is actually sounding the alarm to the others.
One of them should have a flashing red light if it detected smoke. It should be flashing about once per second. The last person to cook had done it over an hour beforehan and it was just pasta (so no more than steam from the stove). Voice Hush Indication: “HUSH MODE ACTIVATED” and “HUSH MODE CANCELLED” voice announcement.
Take the battery out of the smoke detector. Press the “Test” button and hold it down for seconds. An alarm will sound briefly, then the alarm will silence.
Put the battery back in the smoke detector. The detector will chirp one time to indicate the battery is connected.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.